Shelve-it

A Crafters Storage and Workstation System

Special Storage


Ribbon Storage

The Ribbon Storage System is based on our large shelf.  38″ x 19″ high and 6″ deep, it has angled shelves so that the ribbon rolls to the front of the shelf. A front lip on each shelf is raised 1/2″ above that shelf so the ribbon can be fed under the lip.  The bottom shelf is designed to take larger diameter ribbon rolls and the middle and top shelves are designed to take progressively smaller diameter ribbon rolls.

$60 CDN each

image5Ribbon 1

Ribbon Shelf fully loaded (you supply the ribbon)


Storage Staircase

The Storage Staircase takes framelits, thinlets, embossing folders and other similar flat pieces.  It is open on either side so the width of your product does not limit its use like a box would.  The current model has 16 slots in it and measures 11″ deep x 10″ high x 4″ wide. The unit can be made to accommodate more or fewer pieces.

$25 CDN each

Staircase

Platelet 1

Storage Staircase with 16 slots



 

20 Unit Combo

You can load 20 ink pads, markers and re-inker bottles into this cabinet.  The unit is 12.25″ wide, 9 1/2″ high and 6″ deep.

$50 CDN each or 3 for $125

Holds 20 ink pads, markers and reinkers

Holds 20 ink pads, markers and reinkers


13 x 13

This storage box is 13″ x 13″ x 12″ deep.  It fits nicely in IKEA units that have an opening 13 1/4 x 13 1/4.  There are 15 shelves.  2 shelves are glued permanently to the box to add rigidity.  Usually the 4th shelf from both the top and bottom are glued. The rest slide out easily.  Each shelf and the bottom of the box has large half circles cut into the front to make grabbing paper and other flats goods.

$50 CDN each

13 x 13

Two 13 x 13 storage boxes. Good for some IKEA storage systems.